PE Wax For Hot Melt Coating

PE wax for hot-melt coatings is mainly used in hot-melt road marking paints, and has the following characteristics:
(1) High softening point can improve the heat resistance of the coating; low viscosity can be adjusted to improve leveling.
(2) Wear-resistant, anti-scratch, and anti-scratch: The wax is distributed in the coating film to protect the coating film from scratches and provide abrasion resistance.

(3) Control friction coefficient: Its low friction coefficient is usually used to provide excellent slipperiness of the coating film, and at the same time, it has a special silky soft touch due to different types of waxes.
(4) Chemical resistance: due to the stability of the wax, it can give the coating film better water resistance, salt water spray and other properties.
(5) Prevent lamination: Avoid the phenomenon of pasting and lamination of coated or printed objects.
(6) Gloss control: Choose an appropriate model, and depending on the amount added, it will have different effects of matting and increasing gloss, with a good three-dimensional effect.
(7) Prevent the induration and deposition of auxiliary materials such as silicon dioxide, and increase the storage stability of the coating.

TIANSHI hot-melt road marking paint special polyethylene wax, high melting point hardness, strong anti-fouling, specially developed and produced modified polyethylene wax products, with high melting point, high hardness, increased flow Flatness, reducing the cost of use; during the construction of hot-melt road markings, this product can shorten the non-stick time of the paint and improve traffic efficiency, and after the paint is cured, an anti-fouling layer is formed on the surface to maintain the integrity of the markings. Clean nature.