Micronized wax is used in powder coatings to improve wear resistance, smoothness, anti-caking, matting, fluidity and extrusion efficiency. The coarser micronized wax is mixed with other raw materials and extruded by extruder, while the finer micronized wax processed powder is directly dry mixed. Wax additives mainly increase the hardness of the coating and improve wear resistance, or to prevent mechanical scratches on the surface. The Micronized wax generally used in powder coatings can be divided into polyethylene wax, polypropylene wax, PTFE wax, polyamide wax, etc. according to the chemical composition. In terms of compatibility and cost performance, polyethylene wax is better and can meet the general requirements of hardening and scratch resistance, and thus has a wide range of application. In terms of hardening and scratch resistance, Teflon wax is the best and the most expensive. In addition to hardening and scratch resistance, some micronized waxs also have a certain degree of matting, which can be used as a substitute for matting agent in powder coatings that do not require high matting effect. But at this time the amount of addition is generally greater than 2%, sometimes the film has obvious wax particles precipitation. In the application, the micronized wax is divided into two ways of use: front-adding and back-mixing. The wax used in post-mixing is the micronized polyolefin waxes with very small particle size, and the large particle micronized wax should be mixed and extruded with raw materials. [djproduct pid="235"]