Introduction of anti-tack agents for latex gloves

Latex glove anti-tack agent can be used for smooth and non-smooth glove molds and is suitable for glove exterior anti-tack. Avoid the use of chlorinated and powder treated gloves due to the surface is too smooth and grip items off phenomenon. It also facilitates the release of latex-impregnated products and rolled edges. This product has excellent release and anti-stick effects with a smooth surface.

The anti-tack agent of latex gloves is specially used for the anti-adhesive isolation of natural latex, synthetic latex gloves, finger covers and balloons.

① No adhesion between latex products.

② Suitable ratio to water, can make the surface of latex products without traces.

③ Substitute talc and corn starch and other powdered products, suitable for linkage production line, solving the problem of environmental pollution in the workshop.

Product features of anti-tack agent of latex gloves

1, The suitable watering ratio can make the surface of latex products without traces.

2, Not sticky between latex products.

3, Replacement of talc and corn starch and other powder products, suitable for linkage production line, solve the problem of environmental pollution in the workshop.

The scope of application of anti-adhesive agent for latex gloves.

Latex isolate agent is applicable to latex products.

The use of anti-tack agents for latex gloves

1. Dry the ceramic mold at 70 degrees after cleaning
2. Immerse in the solution of coagulant and TF-1250 water-based mold release agent (content 2%-5%) and keep it for 10-20 seconds
3. Dry the mold after powdered water immersion and immerse it in natural latex at room temperature for 20-30 seconds
4. The surface of the glove has good lubricity and anti-adhesive properties after the vulcanized double-sided treatment